Weigh-More Solutions are proud to offer Australian designed Modular Steel weighbridges to benchmark Australian Standards. Weigh-More Solutions have National Measurement Institute (NMI) approvals on our weighbridge range NMI No: 6/10B/69 and our quality Digital Technology components. .
The Weigh-More Solutions AWS106-s Modular Steel Weighbridges are designed using a combination of either epoxy painted or galvanized U-beams, heavy load cell bulkhead structure for load cell mounts and 10 mm floor plate decks. The modular weighbridge sections are easy to transport, unload and assemble onsite in position, ready to commission the Digital Electronics.
The Weigh-More Solutions
AWS106-s/108-s is a quality durable design to M1600 and referencing the Latest
Australian Standard for Bridges AS/NZS 5100.- 2017, we have engineering
certification of the imported weighbridge from our regular designers and
engineers. Design inclusions like extra gusset supports and 20 mm steel plate
at load cell mounting points may provide greater strength than other
weighbridges in the Steel Weighbridge market.
The Weigh-More Solutions AWS106-s Surface weighbridge is normally constructed above ground with the deck 400 mm above the surrounding road levels, with gently sloping ramps approximately 5 meters long at each end, connecting the access road. The surface weighbridge module comes with guide rails as standard.
The design also allows for a Semi-Inground installation with the deck to be installed in a wide shallow pit so the deck can be in line with existing road levels to save space, and / or to allow for end to end weighing with our EZYWeigh Software, to capture axle group weights and split weigh vehicles longer than the weighbridge..
The Weigh-More Solutions AWS109 Pit weighbridge designed to go into a pit as the name suggests and often become part of the site’s hardstand or driveway, this design suits sites with limited available space.
Pit weighbridges usually do not need On or Off ramps, or guide rails, also access is available via removeable access plates in the decks for maintenance & cleaning. The design of our pit weighbridges allows the system to be constructed with or without curbs. Full steel construction and composite steel and concrete designs are available.
Our quality pit weighbridge can be ordered in lengths from 4m – 50m and longer by simply adding weighbridge modules in line to make the required overall length. Combinations and configurations can allow the introduction of axle and gross weighing depending on application requirements.
Other special sizes can be designed, engineered, and purpose built to suit your unique requirements if necessary. The Pit Weighbridge may allow for end to end weighing with our EZYWeigh Software, to capture axle group weights and split weigh vehicles longer than the weighbridge.